Separation of Cu(II) ions from synthetic solutions and waste water by raw and calcined seashell waste
Нема приказа
Аутори
Egerić, MarijaSmičiklas, Ivana D.
Mraković, Ana Đ.
Jović, Mihajlo D.
Šljivić-Ivanović, Marija Z.
Sokolović, Jovica
Ristić, Mirjana
Чланак у часопису (Објављена верзија)
,
© 2018 Desalination Publications
Метаподаци
Приказ свих података о документуАпстракт
The limestone and lime are agents widely used for separation of toxic metals from contaminated water. To reduce the exploitation of natural limestone deposits, appropriate replacements are sought out among the waste materials and by-products. Seashells, accumulated as an abundant waste in coastal areas, have high content of calcium carbonate and so far have shown high efficiency in neutralization and metal immobilization processes. In this study, the removal of Cu(II) ions was investigated using grounded seashell waste (a) without any pretreatment and (b) exposed to temperature treatment in the range 300-900 degrees C. The influence of temperature on the mineral phase transformation, solution pH and the removal efficiency of Cu(II) ions was monitored. Treatments at T > 500 degrees C exhibit positive effect on Cu(II) separation, with the samples partially or completely converted to calcium oxide being the most effective in the entire Cu(II) concentration range (6.34-639 mg/L). The effic...iency of Cu(II) removal was largely associated with the effect on solution pH. The two level full factorial design was used to evaluate the significance of seashell composition (calcium carbonate vs. calcium oxide), granulation, dose and contact time, on the separation of Cu(II) and other cationic pollutants (Fe, Zn, Ni and Pb) from wastewater. The seashell dose and granulation, as well as their interaction, were generally the most influential factors. The variations in the levels of investigated factors had a substantial effect on the process through the indirect effect onto the solution pH. More than 99% of Cu(II) ions were separated at pH > 7, while the final pH range 8.2-12.2 was found optimal for total metal separation (97.6-98.9%).
Кључне речи:
Seashell waste / Temperature treatment / Cu(II) removal / Wastewater treatment / Experimental designИзвор:
Desalination and Water Treatment, 2018, 132, 205-214Финансирање / пројекти:
- Нове технологије за мониторинг и заштиту животног окружења од штетних хемијских супстанци и радијационог оптерећења (RS-MESTD-Integrated and Interdisciplinary Research (IIR or III)-43009)
DOI: 10.5004/dwt.2018.23131
ISSN: 1944-3994; 1944-3986
WoS: 000450790000022
Scopus: 2-s2.0-85057823390
Колекције
Институција/група
VinčaTY - JOUR AU - Egerić, Marija AU - Smičiklas, Ivana D. AU - Mraković, Ana Đ. AU - Jović, Mihajlo D. AU - Šljivić-Ivanović, Marija Z. AU - Sokolović, Jovica AU - Ristić, Mirjana PY - 2018 UR - https://vinar.vin.bg.ac.rs/handle/123456789/7986 AB - The limestone and lime are agents widely used for separation of toxic metals from contaminated water. To reduce the exploitation of natural limestone deposits, appropriate replacements are sought out among the waste materials and by-products. Seashells, accumulated as an abundant waste in coastal areas, have high content of calcium carbonate and so far have shown high efficiency in neutralization and metal immobilization processes. In this study, the removal of Cu(II) ions was investigated using grounded seashell waste (a) without any pretreatment and (b) exposed to temperature treatment in the range 300-900 degrees C. The influence of temperature on the mineral phase transformation, solution pH and the removal efficiency of Cu(II) ions was monitored. Treatments at T > 500 degrees C exhibit positive effect on Cu(II) separation, with the samples partially or completely converted to calcium oxide being the most effective in the entire Cu(II) concentration range (6.34-639 mg/L). The efficiency of Cu(II) removal was largely associated with the effect on solution pH. The two level full factorial design was used to evaluate the significance of seashell composition (calcium carbonate vs. calcium oxide), granulation, dose and contact time, on the separation of Cu(II) and other cationic pollutants (Fe, Zn, Ni and Pb) from wastewater. The seashell dose and granulation, as well as their interaction, were generally the most influential factors. The variations in the levels of investigated factors had a substantial effect on the process through the indirect effect onto the solution pH. More than 99% of Cu(II) ions were separated at pH > 7, while the final pH range 8.2-12.2 was found optimal for total metal separation (97.6-98.9%). T2 - Desalination and Water Treatment T1 - Separation of Cu(II) ions from synthetic solutions and waste water by raw and calcined seashell waste VL - 132 SP - 205 EP - 214 DO - 10.5004/dwt.2018.23131 ER -
@article{ author = "Egerić, Marija and Smičiklas, Ivana D. and Mraković, Ana Đ. and Jović, Mihajlo D. and Šljivić-Ivanović, Marija Z. and Sokolović, Jovica and Ristić, Mirjana", year = "2018", abstract = "The limestone and lime are agents widely used for separation of toxic metals from contaminated water. To reduce the exploitation of natural limestone deposits, appropriate replacements are sought out among the waste materials and by-products. Seashells, accumulated as an abundant waste in coastal areas, have high content of calcium carbonate and so far have shown high efficiency in neutralization and metal immobilization processes. In this study, the removal of Cu(II) ions was investigated using grounded seashell waste (a) without any pretreatment and (b) exposed to temperature treatment in the range 300-900 degrees C. The influence of temperature on the mineral phase transformation, solution pH and the removal efficiency of Cu(II) ions was monitored. Treatments at T > 500 degrees C exhibit positive effect on Cu(II) separation, with the samples partially or completely converted to calcium oxide being the most effective in the entire Cu(II) concentration range (6.34-639 mg/L). The efficiency of Cu(II) removal was largely associated with the effect on solution pH. The two level full factorial design was used to evaluate the significance of seashell composition (calcium carbonate vs. calcium oxide), granulation, dose and contact time, on the separation of Cu(II) and other cationic pollutants (Fe, Zn, Ni and Pb) from wastewater. The seashell dose and granulation, as well as their interaction, were generally the most influential factors. The variations in the levels of investigated factors had a substantial effect on the process through the indirect effect onto the solution pH. More than 99% of Cu(II) ions were separated at pH > 7, while the final pH range 8.2-12.2 was found optimal for total metal separation (97.6-98.9%).", journal = "Desalination and Water Treatment", title = "Separation of Cu(II) ions from synthetic solutions and waste water by raw and calcined seashell waste", volume = "132", pages = "205-214", doi = "10.5004/dwt.2018.23131" }
Egerić, M., Smičiklas, I. D., Mraković, A. Đ., Jović, M. D., Šljivić-Ivanović, M. Z., Sokolović, J.,& Ristić, M.. (2018). Separation of Cu(II) ions from synthetic solutions and waste water by raw and calcined seashell waste. in Desalination and Water Treatment, 132, 205-214. https://doi.org/10.5004/dwt.2018.23131
Egerić M, Smičiklas ID, Mraković AĐ, Jović MD, Šljivić-Ivanović MZ, Sokolović J, Ristić M. Separation of Cu(II) ions from synthetic solutions and waste water by raw and calcined seashell waste. in Desalination and Water Treatment. 2018;132:205-214. doi:10.5004/dwt.2018.23131 .
Egerić, Marija, Smičiklas, Ivana D., Mraković, Ana Đ., Jović, Mihajlo D., Šljivić-Ivanović, Marija Z., Sokolović, Jovica, Ristić, Mirjana, "Separation of Cu(II) ions from synthetic solutions and waste water by raw and calcined seashell waste" in Desalination and Water Treatment, 132 (2018):205-214, https://doi.org/10.5004/dwt.2018.23131 . .