Претраживање
Приказ резултата 21-30 од 53
Absorption boost of TiO2 nanotubes by doping with N and sensitization with CdS quantum dots
(Ceramics International, 2017)
A process of obtaining N-doped TiO2 nanotubes sensitized by CdS nanoparticles is presented, including detailed characterizations performed along the synthesis. Transparent TiO2 films consisting of nanotubes, 2.5 mu m long ...
Photoluminescence of europium(III)-doped (YxSc1-x)(2)O-3 nanoparticles: Linear relationship between structural and emission properties
(Elsevier, 2016)
Europium (III)-doped (YxSc1-x)(2)O-3 nanocrystalline powders of different compositions (x=0, 0.25, 0.5, 0.75 and 1) are synthesized using a polymer complex solution method. Comparative structural and optical characterization ...
Structural and chemical properties of thermally treated geopolymer samples
(Ceramics International, 2017)
This article presents the results of the compositional, structural and morphological study of geopolymers synthesized from metakaolin and an alkali activator. The study involved the investigation of the structural and ...
Synthesis and characterization of nanocrystaline hexagonal boron nitride powders: XRD and luminescence properties
(Ceramics International, 2016)
Nanocrystalline hexagonal boron nitride powders (h-BN) were synthesized from urea and boric acid followed by pirolysis and subsequent heat treatment in nitrogen atmosphere. Materials have been analyzed by means of X-ray ...
Substrate preheating and structural properties of power plasma sprayed hydroxyapatite coatings
(Elsevier, 2016)
The aim of the present study was to investigate the influence of substrate preheating on the structural properties of hydroxyapatite coatings (HACs) deposited by using the high power (52 kW) laminar plasma jet. The deposition ...
Synthesis and characterization of Cr3+ doped TiO2 nanometric powders
(Elsevier, 2016)
Simple route was used for synthesis of nanostructured titania samples doped with 3 and 6 mol% of Cr3+ Titanium(IV)-isopropoxide and water were used as starting materials and as an agents for controlling hydrolysis and ...
Fabrication of non-oxide ceramic powders by carbothermal-reduction from industrial minerals
(Elsevier, 2016)
The most promising method for obtaining a large variety of non-oxide products having important technical uses is carbothermal-reduction reaction (CRR). By using this procedure, SiC and ZrC/SiC powders are obtained from ...
Synthesis and characterization of tungsten carbide fine powders
(Ceramics International, 2015)
Fine tungsten carbide (WC) powder was prepared by solid state reaction between tungsten powder (W) and activated carbon cloth as a new carbon (C) source. The effect of temperature and time of heat treatment as well as the ...
Porous ceramic monoliths based on diatomite
(Ceramics International, 2015)
Porous silica ceramics were obtained at low forming pressure and low sintering temperature by using diatomaceous earth as a silica source and boric acid as an inexpensive additive. The starting raw material, diatomite from ...
Behavior of silicon carbide/cordierite composite material after cyclic thermal shock
(Ceramics International, 2009)
In the present work Mg-exchanged zeolite and silicon carbide were used as starting materials for obtaining cordierite/SiC composite ceramics with weight ratio 30:70. Samples were exposed to the water quench test from 950 ...