Show simple item record

dc.creatorBocciarelli, M.
dc.creatorBuljak, V.
dc.creatorMoy, C. K. S.
dc.creatorRinger, S. P.
dc.creatorRanzi, G.
dc.date.accessioned2018-03-01T15:29:54Z
dc.date.available2018-03-01T15:29:54Z
dc.date.issued2014
dc.identifier.issn0927-0256 (print)
dc.identifier.issn1879-0801 (electronic)
dc.identifier.urihttp://vinar.vin.bg.ac.rs/handle/123456789/173
dc.description.abstractIndentation tests are frequently employed to determine the mechanical properties of materials and are particularly suitable when dealing with small components due to their quasi-non-destructiveness. During an indentation test, the material is subjected to a triaxial stress state and, because of this, the mechanical properties cannot be inferred directly from the experiments. In these cases, suitable procedures must be implemented to derive them and, among the different alternatives available in the literature, the inverse analysis approach has been extensively studied and applied to a wide range of materials and systems. When the inverse analysis procedure relies on the use of a time-consuming finite element model for the modelling of an experimental test, the results are accurate yet computationally demanding. In the present paper, a numerically efficient approach was implemented, which relied on the use of an a priori finite element model reduction procedure. This consists of a Proper Orthogonal Decomposition (POD) model that simulates the response of the material when subjected to an indentation test. The experimental data used in this study as input to the inverse analysis approach consist of both indentation curves and pile-up markings observed at the end of the indentation in the samples. Independent tensile tests were carried out on samples of aluminium alloys AA 6061-O and AA 7075-O. These experimental results were used for the validation of the proposed numerical approach. These results highlighted the accuracy and efficiency of the proposed procedure. (C) 2014 Elsevier B.V. All rights reserved.en
dc.relationAustralian Research Council [DP1096454], University of Sydney (Materials and Structures Research Cluster), NCI National Facility at the ANU
dc.rightsrestrictedAccessen
dc.sourceComputational Materials Scienceen
dc.subjectAl alloyen
dc.subjectMaterial propertiesen
dc.subjectIndentationen
dc.subjectInverse analysisen
dc.subjectModel reductionen
dc.titleAn inverse analysis approach based on a POD direct model for the mechanical characterization of metallic materialsen
dc.typearticleen
dcterms.abstractБоцциарелли, М.; Рингер, С. П.; Буљак, В.; Моy, Ц. К. С.; Ранзи, Г.;
dc.citation.volume95
dc.citation.spage302
dc.citation.epage308
dc.identifier.wos000343781700040
dc.identifier.doi10.1016/j.commatsci.2014.07.025
dc.citation.rankM22
dc.identifier.scopus2-s2.0-84906538046


Files in this item

FilesSizeFormatView

There are no files associated with this item.

This item appears in the following Collection(s)

Show simple item record